Lubrina 2

Lubrina 2 Seamless Auto-Maintenance

Contact us
Seamless Auto-Maintenance

Since the air-blow system can remove residual water completely using clean air, the efficiency of lubrication is enhanced with oil usage ... Read more

  • Cleans one turbine in approximately 20 seconds
  • Oil usage amount is reduced to 1/4
  • Faster maintenance with excellent cost savings

Since the air-blow system can remove residual water completely using clean air, the efficiency of lubrication is enhanced with oil usage only 1/4 of that compared to manual lubrication. Daily maintenance cost is therefore reduced. In addition, the system can remove surplus oil effectively, allowing maintenance in a short time1.

Handpiece and spray compatibility

Example: One turbine and contra angle by Morita and one turbine and contra angle by another manufacturer.

By replacing the coupling, Lubrina 2 facilitates the maintenance of Tri Auto ZX2 and DentaPort contraangles, air driven handpieces (ISO 9168/Type 3 joint) as well as all contra-angles and straight handpieces (ISO 3964/E-Type joint). Lubrina is compatible with 4-hole, 5-hole, and 6-pin connections. With its dual lubrication system, one or two different brands of spray may be used in the same cycle. Several brands of spray are compatible by using an optional spray holder adapter.

 

 

1 Comparison with the long mode of our previous Lubrina
2Approximately 40 seconds for contra-angle handpiece

 

Clean Air-Blow System

The double-conduit design allows the clean air-blow system to achieve clean air. By employing the dual solenoid valves and clean air dedicated conduit, the system can ... Read more

Double-conduit design achieves clean air

By employing the dual solenoid valves and clean air dedicated conduit, the system can supply clean air without a mix of oil. During the water removal process before lubrication, the system removes the water in the head which maximizes lubrication results. During idling after lubrication, the surplus oil can be effectively removed by clean air.

Comparision of Lubrina 2 with an conventional product

Lubrina 2 (Clean Air-Blow System)

Conventional product*

Easy chuck maintenance

For the turbine and 5x speed contra-angle handpiece, it is essential to lubricate and clean the chuck which holds the bar.

Water removal during autoclaving

If autoclave is performed while a large amount of water is left in the conduit of the handpiece, steam will not infiltrate and could cause a sterilization defect. To prevent this, clean air (without a mix of oil) is fed into the water feed, chip air conduit to remove the residual water, thereby reducing the possibility of a problem during autoclaving.

Surplus oil removal reduces idling time before practice

During handpiece rotation, clean air removes the surplus oil which causes blow-out, and thus reduces the idling time necessary before use.

Reduces scattering of oil mist

The built-in oil mist suction mechanism draws in the oil mist generated during maintenance, thereby preventing the mist from scattering to nearby surfaces and devices. In addition, since oil mist is collected into the oil gathering tray, maintenance of the equipment is also easy.

Reduced operating sound

Lubrina 2 of fers a noise reduction of 15dB during operation compared to the original model.

Easy maintenance

The control panel is flat for easy cleaning, and the front door can also be removed for improved access.

Oil spray can delivery system

The low viscosity oil mist penetrates into the inside of the handpiece head and delivers intense cleaning.

 

 

Do you have any questions?

Please fill out this contact form. We will come back to you soon.

Personal information
Your request

Fields marked with * are mandatory.

Do you have any questions?

Please feel free to use our e-mail back service.

Find a dealer